Pilot Iroshizuku Ink Well Box

Pilot Iroshizuku Ink Well Box

$0.00

This is a box to hold 50ml Pilot Iroshizuku Ink wells. This is a glue free design and utilizes 6mm x 3mm magnets.

File Contents:

IroshizukuDesign.svg - created in Inkscape. This is where any modifications to the project are meant to be done. Pieces are deduplicated for design work and no engraving images are included in this file.
IroshizukuTop/Bottom - Files without any engrave designs for cutting the top and bottom pieces.

IroshizukuTop* - Files for cutting the top sections with engraves positioned.

Add To Cart

Picture Notes:

The top section is cut from 1/8” maple plywood and the bottom from 1/8” walnut plywood. Note on the Tsuki-yo variant: This was my first box to cut and is thus missing a few minor improvements. The most noticeable is that it’s missing the front and back magnets (only containing side magnets for latching the top to the bottom). This did not provide adequate holding power to be able to lift the box holding onto just the top section. With 4 sets of magnets, the piece should be able to be lifted up by the top piece without the bottom falling off.

Assembly difficulty: 3/5

Care should be taken when assembling to orient the magnets properly in relation to each other.

Required Materials:

  • 1/8” plywood

  • 6x3mm magnets

Recommended Tools: